![]() When you start placing plants and arranging your decorative accents on your new DIY live-edge shelf, make sure you don't go over the weight maximum! Your brackets will most likely come with a weight limit along with the installation instructions, but you can always ask the folks at the hardware store for a rough estimate. Brace yourself for a tidal wave of compliments! Attach your shelf, and it's ready to go! All that effort will be so worth it when you finally see your one-of-a-kind shelf on display.Make it as smooth as possible so that the natural wood striations and swirls pop! When the finish has dried, use sandpaper to smooth out the surface one last time.Oil-based finishes like linseed oil tend to have a warm, yellowish tint, whereas finishes like dewaxed shellac have a cooler-to-neutral tone. Apply your chosen finish on the wood slab.Ensure the posts are pointing upward when you attach the shelf, or else your wood slab will fall off. Some bracket posts will have an upward angle to help counterbalance the weight of the items on your shelf. Using your drill, anchor the bracket into place with long screws suitable for a floating shelf. Using a level, draw a straight line where you'd like to hang your shelf.Remove the slab from the posts before you attach the bracket to the wall. Slide your shelf onto the bracket posts to double-check that the holes line up. Blow into the hole and give it a tap to remove any sawdust. Drill your holes into the wood slab, being careful not to splinter the wood. Measure the length of the bracket post and use a drill bit large enough to create a hole of the same depth. ![]() Depending on your chosen bracket, you may have one large one with multiple posts or 2–3 small ones with single posts you can space out to your preferred size. This way, the shelf will slide right into place. For your shelf to fit onto the bracket, it needs to have its holes spaced precisely where the bracket posts sit. The shelf will conceal the bracket once it's assembled on the wall. Measure and mark where your drill holes will go so your bracket posts match up. ![]() If needed, use a miter saw to clean up any splintering bits jutting out from the edge.
0 Comments
Leave a Reply. |